Operating a dbs using the remote control, Using the remote control for the tv operation, Setting the manufacturer code – JVC CA-NXF30 User Manual
Page 57
54
O
p
e
ra
ting othe
r e
quipme
n
t
Before the TV operation, select the remote control
mode for the TV.
■ IMPORTANT
• Slide the remote control mode
selector to the lowest position.
1
Press [TV].
2
Operate the remote control by
pointing it at the TV.
.
NOTE
• When the remote control mode selector is slid to
the lowest position and [TV] is pressed, some
buttons may not work.
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
■ IMPORTANT
• Slide the remote control mode
selector to the lowest position.
1
Press [DBS].
2
Hold down [DBS/VCR
F
].
• Hold down [DBS/VCR
F
] until you finish
step 5.
3
Press [ENTER].
4
Press number buttons to enter the
manufacturer code.
Examples:
For an Echostar DBS: Press [2], then [1].
For a Sony DBS: Press [2], then [0].
When the manufacturer of your DBS has 2 or
more codes, enter the manufacturer codes in
turn and find the one that operates the DBS
and the remote control properly.
The initial code setting is “01 (G. I.)”.
5
Release [DBS/VCR
F
].
NOTE
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
• Manufacturer codes are subject to change
without notice. You may not be able to operate
the DBS produced by the manufacturer.
• After replacing the batteries of the remote
control, set the manufacturer code again.
Remote
control button
Usage
[TV
F
]
Turns on/off the TV.
[TV/VIDEO]
Changes between the TV and
video input.
[CH +/
–
]
Changes channels.
[TV VOL +/
–
]
Adjusts volume.
Number
buttons (1-9, 0,
100+)
Selects the channels.
[TV RETURN]
Changes between the previously
selected channel and the current
channel.
Using the remote control for the TV
operation
Operating a DBS using the
remote control
Manufacturer
Code
G. I.
01, 02, 03, 04, 05, 06, 07, 08
Echostar
21
Hamlin
15, 16, 17, 18
Jerrold
01, 02, 03, 04, 05, 06, 07, 08
Pioneer 13,
14
RCA
19
Scientific Atlanta
09, 10
Sony
20
Zenith
11, 12
Setting the manufacturer code
NX-F30[U].book Page 54 Tuesday, April 21, 2009 6:23 PM