JVC CA-NXF30 - Manual (Page 68)

65
Refer
ence
■General (continued)
■For a loaded disc
Problem Possible cause Possible solution
Reference
page
No sound is produced. The speakers are not
connected correctly. Connect the speakers correctly.
6
Headphones are connected. Disconnect the headphone plug. 14
The sound is turned off. Restore the sound. 13
If “NO AUDIO” is displayed in
the display window, the disc
may have been produced
through illegal copying. Check the disc at the store where
it was purchased.
–
The sound is weak and
can hardly be heard. The volume level is low. Increase the volume level.
12
The sound is distorted. The volume is too high. Turn down the volume. 12
A radio broadcast has
interference from noise. The antennas are not
connected correctly. Connect the antennas correctly.
5
A radio broadcast
cannot be received.
A noise is produced
from the rear of the main
unit.
The internal cooling fan
produces the noise as the fan
rotates.
The noise is not a malfunction.
The cooling fan is used to prevent
overheating of the main unit.
12
The HDMI CEC function
does not work. The connected TV is not
compatible with the HDMI CEC
function.
Refer to the operation manual of
the TV. –
“OFF” is selected for the “CEC”
setting.
Select “ON 1” or “ON 2” for the
“CEC” setting.
39
When you disconnect
the HDMI cable and
connect it again, the
HDMI CEC function
does not work properly. The previous connection setting
is stored on the main unit.
Select “OFF” for the “CEC” setting,
and then select “ON 1” or “ON 2”
again.
39 and 57
Problem Possible cause Possible solution
Reference
page
A disc cannot be played
back. If “REGION CODE ERROR!”
appears on the TV screen, the
region code number of a disc is
not compatible with this system.
(only for a DVD VIDEO) Confirm the region code number
compatible with this system.
60
If “CANNOT PLAY THIS DISC”
appears on the TV screen, the
disc cannot be played back with
this system. Confirm the disc type whether it is
playable with this system.
60
The disc is upside down. Place the disc on the disc tray with
the printed surface facing up.
19
Moisture has condensed on the
lens. Leave the main unit turned on,
wait for approximately 1 or 2
hours, and then operate the main
unit.
58
Troubleshooting (continued)
NX-F30[U].book Page 65 Tuesday, April 21, 2009 6:23 PM