JL Audio MCS-3800 - Manual (Page 33)

33
To Assign a Fader or a Touch Sensor
Since the faders and touch sensors are Bank-switchable, select
the desired Bank before entering Assign mode.
In other words, if assigning the first fader, the Bank switch will
determine if the first fader is channel 1, or 9, or 17, or 25.
Press Assign to enter Assign mode. The yellow LED is lit.
After entering Assign mode,
Touching a fader selects the touch sensor only. You are now
able to assign the command sent when the fader is touched.
Moving the same fader selects the fader itself. You are now
able to assign the command sent when the fader is moved.
At that point, the display “holds” the currently selected control.
If you change your mind and wish to edit a different control
instead, press Assign to exit assign mode. Press Assign again to
re-enter Assign mode and select a different control.
Use the LCD and rotary encoder knobs to edit the control.
Turn the right-most encoder knob to reveal additional editable
parameters.
After making the edit, press Enter on the Keypad to store the
changes to memory.
64
More About Sending Locate Commands
At each keypad number press, the locate name and locate time
automatically are updated.
That is, press 1, the display shows Loc 01 "Locate 01"
Press 3, the display show Loc 13 "Locate 13".
When Enter is pressed on Keypad, the following happens:
(1) The locate time in LCD is sent via MMC (and 9 Pin)
(2) The locate time is shown in the 7-segment display.
(3) If time code is being received, the locate time is held
momentarily before the display is released to display either
tally or current time code.
(4) The locate number field is reset. Pressing another
numbered key on the keypad causes the number to appear in
the LCD with a leading zero.
For example, if you press 3, 7, 2, Enter, and 3, the display shows
LOC:03, LOC:37, LOC:72 (Enter), LOC:03
When time code is not being received, the 7 segment display
holds the last time displayed, whether it is the result of
incoming time code, incoming tally, or a sent locate time.
Locating by Direct Address
To send a Locate by specifying a time code, press Locate and
enter the time. Press Enter to validate the entry.
Last function
Press Last to re-send the last locate.
The Last key instantly (that is, without pressing Enter) does the
following:
(1) The locate time in LCD is sent via MMC (and 9 Pin).
(2) Locate time is shown in 7-segment display.
(3) If time code is being received, the locate time is held
momentarily before the display is released to display either
tally or current time code.