JL Audio MCS-3800 - Manual (Page 98)

September 16, 2009 920394 Ethernet Interface Installation Page 2
2. The Ethernet MAC address is printed on a label attached to
the card. In the unlikely event that this address is needed,
you might want to copy it down before installing.
3. Install the Card into the "Slot 1" position using the screws
previously attaching the blank plate or other interface card
II. Initialization
1. First-time initialization.
Certain internal memory locations must be initialized
before operation may proceed.
Hold down the Up and Down arrow keys.
a. Turn on the power. Continue holding the keys until the
display blanks.
b. This initializes the unit as follows:
IP Address = 192.168.254.101
Gateway =
192.168.254.198
Mask = 255.255.255.000
Port = 00023
2. Modifying the IP Address and/or Port.
If it is desired to change the default IP address or Port
number, this needs to be done just once. The results are
saved to nonvolatile memory.
a. While the unit is powered, hold down the SHIFT key
and momentarily push the UTILITY button.
b. The current IP Address will be shown in the display. If
you do not wish to change this address, press ENTER.
c. If you wish to change this, press numeric pad keys.
This does not scroll. If you make a mistake, press the
CLEAR button once, and the current number will
reappear.
d. When satisfied with the displayed value, press the
ENTER key. The display will then display the
Gateway value. If you don't wish to change this, press
ENTER again. Press ENTER again to step past the
Mask value.