JL Audio MCS-3800 - Manual (Page 83)

14
Mounting MCS-3000X Expander to Controller
Important: Make All Connections with the Power Off.
Turn the power off of all MCS-3000 units before proceeding.
Plan Work Area
You will want to work at a spacious, well lit surface.
Spread a cloth on the surface to avoid scratching units.
Remove Top of MCS-3400 or MCS-3800 Controller
Using the allen key provided with the Expander, remove the
six top panel screws of the Controller. Remove any optional
Cards from the card slots. Remove one screw under front
center. Lift the whole top panel, a little forward and up. Invert
and lay control-side down on a soft surface. (Circuit side up.)
Remove Top of MCS-3000X
Remove the six top panel screws of the Controller.
Lift top panel, a little forward and up. Invert and lay control-
side down on a soft surface. (Circuit side up.)
Move Left End Bell
Remove the two screws that secure Controller's left end bell.
(These screws will be tight). Attach the left end bell to the left
side of the Expander.
Connect Controller to Expander with Plates Provided
Place the Expander to the left of the Controller, side by side.
Attach the thicker plate to the bottom of both units.
Lay thin (spring steel) plate on top of both units.
Replace top panels of the Controller, guiding in the Time Code
jack and the LCD Contrast control into their holes. Replace the
top panel of the Expander. Replace top screws. Replace
Controller bottom screw. Replace any optional Cards in their
card slots.
83
Technical Information
Dimensions
MCS-3800, without wrist rest and end bells:
20.15" x 9.75" x 2.00"
MCS-3400, without wrist rest and end bells:
16.15" x 9.75" x 2.00"
MCS-3000X, without wrist rest and end bells:
9.26" x 9.75" x 2.00"
MCS Surround Panner, without wrist rest and end bells:
4.63" x 9.75" x 2.00"