JL Audio MCS-3800 - Manual (Page 91)

6
The Function Buttons Section .............................. 65
This chapter discusses how to use the assignable
F buttons, W Buttons, the Cursor Buttons and M buttons.
Attributes of Function Buttons ................................ 65
Assigning Function Buttons, an Overview ............. 67
To Assign F and M Buttons ..................................... 68
Editable Parameters of F and M Buttons ................. 69
F and M Button Command Types ........................... 70
To Assign W and Cursor Buttons ............................ 73
Editable Parameters of W and Cursor Buttons........ 74
Function Button Operation Notes ........................... 76
The System Section................................................ 77
This chapter discusses Utility Mode And Keypad Program
Change Mode, the LCD and LED Time Code Display.
Utility Mode ............................................................. 77
Manually Exiting Special Mode ......................... 78
Memory Protect .................................................. 78
Dump ................................................................. 78
Show TC ............................................................. 79
Bank Name ........................................................ 79
Offset (Feet and Frames) ................................... 79
Jog and Shuttle Speed ........................................ 80
Program Change Mode ............................................ 81
Time Code Display .................................................. 82
Display TC and Locates or Program Changes ... 82
Show SMPTE, No Frames, Feet : Frame ............ 82
Technical Information .......................................... 83
Dimensions .............................................................. 83
Initialization Procedure ........................................... 84
Initialized Settings .................................................... 84
Warranty ................................................................ 89
Quick Operation Reference (7 Page Summary) .. 90
91
Quick Operation Reference
LCD Displays Encoder Names or Bank Name
If a Page button is lit, the LCD shows the names of the five
"Virtual Encoders". If these names have not edited, they are
"VKNOB1, VKNOB2, VKNOB3, VKNOB4, VKNOB5."
If no Page button is lit, the LCD show the Bank Name.
Bank Switchable Controls
The faders, their touch sensors, the encoders, and the buttons
above the faders, are all Bank switchable.
Shiftable Controls
The F, M, W, Cursor, and Transport Buttons can have an
alternate Shifted assignment.
Encoder Selection
For each channel, there are 8 Pages of 5 encoders.
Prior to turning an encoder knob,
Press 1 of the 4 Bank switches to select the Bank.
Press 1 of the 8 Select buttons at the top of a fader channel.
Press 1 of the 8 Page buttons above the LCD.
You have the equivalent of over 1200 independantly
programmable rotary encoders.
To Assign A Control
1. Press Assign to enter Assign mode. The yellow LED is lit.
2. Select a control for editing.
At that point, the display “holds” the currently selected control.
If you change your mind and wish to edit a different control
instead, press Assign to exit assign mode. Press Assign again to
re-enter Assign mode and select a different control.
3. Use the LCD and rotary encoder knobs to edit the control.
Turn the right-most encoder knob to reveal other parameters.
4. After making the edit, press Enter on the Keypad to store the
changes to memory. Either select another control, or press
Assign to exit Assign Mode.