JL Audio MCS-3800 - Manual (Page 63)

34
Editable Parameters for the Faders and Touch Sensors
Name
Press the Cancel/Clear key in the Keypad to clear the name.
Use the Cursor buttons to the left of the LCD to move the
cursor. Turn the first encoder to dial in the letters and numbers.
The top row of the LCD show the control's real (permanent)
name. The bottom row of the LCD is the user editable name.
Command
Faders and Touch Sensors send either Controllers or Notes.
Any control can be turned off.
Number
Selects the Controller or Note number.
Channel
Selects MIDI Channel 1 through 16.
Minimum
Minimum controller or note velocity value.
The value sent when the fader is in its lowest position.
Maximum
Maximum controller or note velocity value.
The value sent when the fader is in its highest position.
63
Storing a Locate Manually with Set Locate
Press Set Locate to store a Locate time, press Enter.
Next, give the a two digit number, from 00 to 99, and press
Enter. The cursor moves to the name field.
When editing a name, use the right and left cursor buttons (to
the left of the LCD to move the cursor. Use the encoder that is
below the locate name (the second from the right-most) to dial
in the name. Press Enter.
Storing a Locate by Capturing on the Fly
Simply press Set Locate while time code is coming in.
The Locate Number will automatically increment.
The Locate will automatically be named.
Sending a Locate Command
To send a Locate, do not press Locate.
Just type the two digit locate number, and press Enter to
send the Locate command.
The command is not sent until you press Enter.