JL Audio MCS-3800 - Manual (Page 38)

38
To Assign Mute, Solo, Aux and Select Buttons
Since the Mute, Solo, Aux, and Select buttons are Bank-
switchable, select the desired Bank before entering Assign
mode.
Keep in mind that the Select buttons have two functions.
(1) They are used to select a set of 40 virtual encoders
associated with each channel. (2) For maximum user-flexibility,
they may also be programmed to send a command. If you wish
to reserve the Select buttons to only select Encoders, and not to
send a command, they may be assigned to send no command.
Press Assign to enter Assign mode. The yellow LED is lit.
After entering Assign mode, press a button to select it.
At that point, the display “holds” the currently selected control.
If you change your mind and wish to edit a different control
instead, press Assign to exit assign mode. Press Assign again to
re-enter Assign mode and select a different control.
Use the LCD and rotary encoder knobs to edit the control.
Turn the right-most encoder knob to reveal additional editable
parameters.
After making the edit, press Enter on the Keypad to store the
changes to memory.
59
Jog and Shuttle Operation
The Jog / Shuttle mechanism can send MMC and Controller
commands. If an optional 9 Pin card has been installed, 9 Pin
commands are sent to control professional VTRs.
Jog On / Off Feature
Any Transport or Function button can be turned into a master
On / Off button for Jog and Shuttle. Being able to turn Jog and
Shuttle on and off instantly means that you do not have to
worry about accidently engaging Jog or Shuttle at the wrong
time.
You can choose which button is the most convenient for you.
For example, to make "W5" the master Jog and Shuttle enable
button,
Press Assign to enter Assign Mode.
Press W5 to select it.
Under "Command", dial up "Jog"
Press Enter.
Now W5 will turn on and off the Jog and Shuttle mechanism.
When Off the shuttle direction LEDs turn off.
When On, the shuttle direction LEDs are on.