JL Audio MCS-3800 - Manual (Page 40)

40
Maximum (or Velocity)
Maximum controller or note velocity value.
If the switch is Latch Off (see below), this is the value sent
when the switch is pressed.
If the switch is Latch On (see below), this is the value sent
every other press, when the LED turns On.
Group
The selected control that you are currently editing can be made
a group member.
By rotating the encoder under the word Group, the LCD
prompts you to select which fader will be the Master for that
control.
Buttons that are grouped can still be pressed individually.
Latch
When Latch is on, the button will activate "push once for on,
push again for off". When Latch is off, the button is
momentary, that means its only on for as long as you hold
down the button.
57
Transport Operation
Record Safety Feature
To use the Record button, hold Play and Record at the same
time.
Initialized State of Transports and M Buttons
In the units initialized state from the factory, (assuming that the
control assignment have not been edited), the Transports and
Jog / Shuttle have been pre-assigned to send commands
dependent upon the state of the M buttons.
M1 enables MMC Machine #1.
M2 enables MMC Machine #2.
M3 enables MMC Machine #3.
M4 enables MMC Machine #4.
If you are controlling machines that respond to MIDI Machine
Control, you will want to make sure that the machines are set
to the correct ID#, and the MMC is enabled. The procedures for
doing this vary widely, and you will need to consult the
documentation accompanying the machine.
M5 enables CS-10 Emulation.
The CS-10 and CS-10
2
are widely used MIDI Controllers from
JLCooper. They are supported by most disk-based audio
editing systems.