SpectronIQ PD-1100 - Manual (Page 6)

iv
Conformity and
Compliance
FCC Compliance Statement
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
when the equipment is operated in a
residential installation. This equipment
generates, uses, and can radiate radio
frequency energy and, if not installed
and used in accordance with the
instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a
particular installation. If this equipment
does cause harmful interference to
radio or television reception (this can be
determined by turning the device off
and on), the user is encouraged to try to
correct the interference by one or more
of the following measures:
• Reorient or relocate the
receiving antenna.
• Increase the separation between
the equipment and the receiver.
• Connect the equipment to an
outlet on a circuit different from
that to which the receiver is
connected.
• Consult the dealer or an
experienced radio/TV technician
for help.
Caution:
To comply with the limits for an FCC
Class B computing device, the user
should use the shielded signal cable and
power cord supplied with the unit. The
FCC warns that changes or modifications
of the unit not expressly approved by
the party responsible for compliance
could void the user’s authority to
operate the equipment.
OMPD800.book Page iv Thursday, September 21, 2006 1:39 PM