Sanyo CHX03652 - Manual (Page 53)

3-9
1
2
3
4
5
6
7
8
Control of Mini ECO-i SYSTEM
2. Wireless Remote Controller
How to Install the Wireless Remote Controller
Receiver
RCS-SH80AAB.WL for 4-Way Air Discharge Semi-
Concealed (X Type)
2-1. Installing the Receiver Unit
The only corner where the receiver unit can be installed is the
one shown in Fig. 3-1. Therefore, consider the direction of the
panel when it is installed on the indoor unit.
(1) Remove the intake grille.
(2) Remove the screws that fasten the adjustable corner cap,
then slide the adjustable corner cap to the side to remove
it. (Fig. 3-2)
(3) The square hole used for the panel wiring is fi lled with
packing (sponge material) used for insulation.* Remove
the packing, then pass the wiring from the wireless re-
ceiver unit through the grill.
Twist the wires together and use a cable fastener to fasten
them and fi x with screw, then replace the packing in the
hole as it was before. (Fig. 3-3)
* If this packing is not used, there is danger of condensa-
tion on the wiring. Be sure to replace the packing.
(4) After completing wiring as described in “Wiring the Re-
ceiver Unit” on the next page, twist the wires together and
use a cable fastener to fasten them, leaving a length of
wiring that is long enough to permit removal of the adjust-
able corner cap.(Fig. 3-3)
(5) Install the receiver unit in the panel. At this time, slide the
receiver unit so that each of the 3 tabs fi ts into its respec-
tive hole. Take care that the wires are not pinched.
(Fig. 3-4)
* Refer to the instruction manual provided with the panel.
NOTE
Do not twist the control wiring together with the power wir-
ing because this may cause a malfunction.
Install a noise filter or take other appropriate action if elec-
trical noise affects the power supply circuit of the unit.
* For wiring and test run procedures, refer to “Wiring the
Receiver Unit” and “Test Run.”
Indoor unit
refrigerant tube side Indoor unit
drain tube side
Receiver unit
installation position
(Right side of electrical
component box)
Indoor unit electrical
component box
Fig. 3-1
Ceiling panel
screw
Adjustable corner cap
Adjustable corner cap
Fig. 3-2
Remove the packing, twist
the wires together and fasten
them with the cable fastener.
Then replace the packing.
Fig. 3-3
Fig. 3-4