Servis-Rhino 2160 - Manual (Page 130)

OPERATION
2160 02/10 Operation Section 4-32
© 2010 Alamo Group Inc.
OPERA
T
ION
9.5 Shutting Down the Attached Head
To shut down attached boom head, first bring the
tractor to a complete stop. Keep the engine
speed at normal operating speed of 540 RPM,
and push the Motor Switch IN to the Stop position.
The mower head will come to a complete stop
with in 15 seconds.
Park the tractor on a level surface, place the
transmission in park or neutral and apply the
parking brake, shut down the engine, remove the
key, and wait for all motion to come to a complete
stop before exiting the tractor. OPS-B- 0011_H
BEFORE leaving the tractor seat, always set the parking brake and/or set
the tractor transmission in parking gear, disengage the PTO, stop the
engine, remove the key, and wait for all moving parts to stop. Place the
tractor shift lever into a low range or parking gear to prevent the tractor
from rolling. Never dismount a Tractor that is moving or while the engine
is running. Operate the Tractor controls from the tractor seat only.
(SG-9)
10. TRACTOR, BOOM, AND ATTACHED HEAD STORAGE
Properly preparing and storing the unit at the end of the season is critical to maintaining its appearance and to
help ensure years of dependable service. The following are suggested storage procedures:
• Thoroughly clean all debris from boom and head to prevent damage from rotting grass and standing water.
• Lubricate all grease points and fill oil levels according to the maintenance lubrication schedule.
• Tighten all bolts to the proper torque. Ensure all pins and other hardware are in place.
• Check the boom arm and head for worn and damaged parts. Perform repairs and make replacements so
that the mower will be ready for use at the start of the next season.
• Store the unit in a clean and dry location.
• Use spray touch-up enamel where necessary on bare metal surfaces to prevent rust and to maintain the
appearance of the mower. OPS-B- 0012_F