SUPER MICRO Computer 6014H-8 - Manual (Page 26)

2-8
S UPER S ERVER 6014H-8/6014H-82/6014H-X8 Manual
2-5 Checking the Serverboard Setup
After you install the 6014H-8/6014H-82/6014H-X8 in the rack, you will need
to open the unit to make sure the serverboard is properly installed and all
the connections have been made.
1. Accessing the inside of the System (see Figure 2-5)
First, release the retention screws that secure the system to the rack.
Grasp the two handles on either side and pull the system straight out
until it locks (you will hear a "click"). Next, depress the two buttons on
the top of the chassis to release the top cover (1). Push the cover away
from you (toward the rear of the chassis) until it stops (2). You can
then lift the top cover from the chassis to gain full access to the inside of
the server.
To remove the system from the rack completely, depress the locking tabs
in the chassis rails (push the right-side tab down and the left-side tab
up) to continue to pull the system out past the locked position. Another
set of locking tabs will stop the chassis before it comes completely out
of the rack.
2. Check the CPUs (processors)
You should have one or two processors already installed into the
serverboard. Each processor needs its own heatsink. See Chapter 5
for instructions on processor and heatsink installation.
3. Verify the proper CPU clock ratio setting
If the CPU speed is not automatically detected you will need to set the
correct speed with the BIOS Setup utility. See the CPU speed setting in
BIOS (Chapter 7) for setting the proper CPU speed. (Most processor
speeds are automatically detected so this step should be unnecessary.)
4. Check the system memory
Your 6014H-8/6014H-82/6014H-X8 server system may have come with
system memory already installed. Make sure all DIMMs are fully seated in
their slots. For details on adding system memory, refer to Chapter 5.