SUPER MICRO Computer 6014H-8 - Manual (Page 38)

5-2
S UPER S ERVER 6014H-8/6014H-82/6014H-X8 Manual
!
5-2 Processor and Heatsink Installation
When handling the processor package, avoid placing direct
pressure on the label area of the fan. Also, do not place the
serverboard on a conductive surface, which can damage the
BIOS battery and prevent the system from booting up.
Socket lever
CPU Installation
1. Lift the lever on the CPU socket:
Lift the lever completely as shown
on the picture on the right; other-
w i s e , y o u w i l l d a m a g e t h e C P U
socket when power is applied. In-
stall CPU1 first.
IMPORTANT: Always connect the power cord last and always remove it
before adding, removing or changing any hardware components. Make sure
that you install the processor into the CPU socket before you install the
CPU heatsink.
Pin 1
2. Insert the CPU in the socket,
making sure that pin 1 of the CPU
aligns with pin 1 of the socket (both
corners are marked with a triangle).
When using only one CPU, install it
into CPU socket #1. (Socket #2 is
automatically disabled if only one
CPU is used.)
3. Press the lever down until you
hear a *click*, which means the
CPU is securely installed in the
CPU socket. Repeat these steps
if you wish to install a second
processor into CPU socket#2.
Socket lever in the
locking Position