SUPER MICRO Computer 6014H-8 - Manual (Page 3)

Preface
About This Manual
This manual is written for professional system integrators and PC techni-
cians. It provides information for the installation and use of the Super-
Server 6014H-8/6014H-82/6014H-X8. Installation and maintainance should
be performed by experienced technicians only.
The SuperServer 6014H-8/6014H-82/6014H-X8 is a high-end, dual proces-
sor server based on the SC813S-500 1U rackmount server chassis and the
X6DHR-8G/X6DHR-8G2/X6DHR-X8G serverboard, which supports single or
dual Xeon TM processors at a Front Side (system) Bus speed of 800 MHz
and up to 16 GB of DDR2-400 (for the X6DHR-8G2) or 16/32 GB of DDR333/
266 (for the X6DHR-8G/X6DHR-X8G) SDRAM.
Manual Organization
Chapter 1: Introduction
The first chapter provides a checklist of the main components included with
the server system and describes the main features of the SUPER X6DHR-
8G/X6DHR-8G2/X6DHR-X8G serverboard and the SC813S-500 chassis,
which make up the SuperServer 6014H-8/6014H-82/6014H-X8.
Chapter 2: Server Installation
This chapter describes the steps necessary to install the SuperServer
6014H-8/6014H-82/6014H-X8 into a rack and check out the server configu-
ration prior to powering up the system. If your server was ordered without
processor and memory components, this chapter will refer you to the ap-
propriate sections of the manual for their installation.
Chapter 3: System Interface
Refer here for details on the system interface, which includes the functions
and information provided by the control panel on the chassis as well as
other LEDs located throughout the system.
iii
Preface