SUPER MICRO Computer 6014H-8 - Manual (Page 58)

5-22
S UPER S ERVER 6014H-8/6014H-82/6014H-X8 Manual
Watch Dog Enable/Disable
JWD enables the Watch Dog func-
tion. Watch Dog is a system moni-
tor that can reboot the system when
a software application is "hung up".
Pins 1-2 will cause WD to reset the
system if an application is hung up.
P i n s 2 - 3 w i l l g e n e r a t e a n o n -
maskable interrupt signal for the ap-
plication that is hung up. See the
table on the right for jumper settings.
Watch Dog can also be enabled via
BIOS.
Note: When enabled, the user needs
to write their own application soft-
ware in order to disable the Watch
Dog Timer.
Jumper
Position
Pins 1-2
Pins 2-3
Open
Definition
WD to Reset
WD to NMI
Disabled
Watch Dog
Jumper Settings (JWD)
SCSI Termination Enable/
Disable
Jumpers JPA2 and JPA3 allow you
to enable or disable termination for
the SCSI connectors. Jumper JPA2
controls SCSI channel A and JPA3
is for channel B. The default set-
ting is open to enable (terminate)
both SCSI channels.
Note: In order for the SCSI drives
to function properly, please do not
change the default setting set by
the manufacturer. See the table on
the right for jumper settings.
Jumper
Position
Open
Closed
Definition
Enabled
Disabled
SCSI Channel Termination
Enable/Disable
Jumper Settings
(JPA2, JPA3)