3 projector power on, 4 language menu, 1 batteries – Sim2 Multimedia SVP 420 HB User Manual
Page 10: 5 input selection, 6 picture adjustment, Englishenglishenglishenglishenglish
SVP 450 PLUS - SVD 500 PLUS
9
ENGLISHENGLISHENGLISHENGLISHENGLISH
3.2 RC 3100 User Remote Control
Read this chapter through carefully before altering any
values or making any adjustments.
3.3 Projector Power On
- To turn the projector on or off, press the power swith, (a
red led lights up on the rear panel), if after a few seconds
the led does not turn green, press
for a second.
- To turn the projector off, press
for a longer time. Wait
at least 3 seconds before turning the projector on again,
or else the command will be ignored.
3.4 Language menu
To select the language desired for the screen displays:
Press push-button
• • • for a second, the following will
appear:
INPUT SELECT
1
2
3
4
5
6
7
8
9
SCART / VIDEO 1
VIDEO 2
SCART / S-VHS
SCART / RGB
S-VHS
YCrCb
BNC 15 KHz
BNC 31-38 KHz
0
YCrCb 32 KHz
VGA
LANGUAGES
Deutsch
English
Espanol
Francaise
Italiano
Portoguese
3.1 Batteries
Handling the remote control and batteries:
- Avoid exposing the remote control to heat and humidity.
- When not using the remote control for a long period of
time, remove the batteries.
- Do not use new and old batteries together or batteries
of a different voltage or type.
- Do not drop or mishandle the remote control.
- Use the remote control within its operating range (about
10 metres and a 30° angle)
Note:
The RC3100 remote control is powered by two AA
batteries.
The left arrow indicates the language in use. Use the arrows
to select the desired language.
Press ENTER to confirm the selection.
Press ESC to exit the menu.
3.5 Input selection
Select a programme AV and/or the relevant input
connector.
To select the input directly use a numerical button or: press
push-button AV/O to enter the video input menu. The
following menu will be displayed:
Press the relevant number to select the desired video input;
VIDEO 2
Note:
The input Num.0 appairs only on the models
provided by the progressive component input.
i.e. if one wishes to select video 2 press push-button 2 and
the following indication will be displayed for a brief period of
time.
3.6 Picture adjustment
To change the value of CONTRAST, BRIGHTNESS,
COLOUR, HUE (STANDARD NTSC), PEAKING.
Press the
button for a second, one of the five
adjustments will appear (contrast, brightness, colour,
peaking and hue).
2 AA
1.5 V
batteries
RC 3100
BACK OF THE
REMOTE CONTROL