Sim2 Multimedia SVP 420 HB - Manual (Page 5)

SVP 450 PLUS - SVD 500 PLUS
4
2.1 Projector Identification
The model and serial number are located on the
projector’s rear label
Fig. 1 .
Record the serial number in the space below and quote it
each time you ask for information or technical assistance
from
Multimedia SPA.
Mod. ......................Serial number.........................
Before operating the projector, read carefully the
safety labels on the rear panel.
The lightning flash symbol on the label and the 33 Kv
indication are intended to advise the user that inside the
projector there are components that can produce electric
shock.
Warnings:
To avoid damages, fire or electric shocks do not
expose this projector to the rain or damp. Qualified
service personnel should service and adjust the
projector’s internal parts.
- Never put objects of any kind through the projector’s
ventilation slots as they might touch high voltage
components or cause short circuits that could be a fire
or electric shock hazard.
- Do not spill any liquid spill on the projector.
- If an object or liquid manages to get inside the projector,
unplug it immediately and call for the assistance of
qualified personnel.
Fig. 1
MAINS POWER
Mains power: 120-240Vac 50-60Hz +6%-10%
Max absorbed current: 2.5 A
RMS
1.1 Safety and Regulations
A) Safety - conform to:
EN60950:
Equipment for information technology including electric
office equipment.
Safety.
German Law (RoV) -1987:
X-ray emission
USA Code of Federal Regulations: Title 21(21CFR)
X-ray emission
B) Electromagnetic Compatibility - conform to:
EN 55022:
Limits and measuring methods of radio disturbance
produced by information technology equipment.
EN 50082-1:
Generic immunity law.
EN 61000-3-2:
Limits for harmonic current emission
EN 61000-3-3:
Limits - Section 3 Limitation of Voltage Fluctuation and
Flicker in Low Voltage Supply System for Equipment
with Rated Current SYMBOL 163\f “Symbol” 16A.
••••• Warning
Multimedia S.P.A declines all responsibility
for damages to things and/or people caused by
incorrect mechanical or electrical installation of the
projector.
2 GENERAL INFORMATION
The instructions detailed in this manual for the
installation and normal operation of the projector must
be followed precisely.
Installation and preliminary adjustments must be
performed by qualified service technicians.