Sim2 Multimedia SVP 420 HB - Manual (Page 6)

SVP 450 PLUS - SVD 500 PLUS
5
ENGLISHENGLISHENGLISHENGLISHENGLISH
- Do not attempt to use it as it could be dangerous or
even worsen the damage.
- If the projector is not used for long periods of time or
during storms, unplug the projector temporarily from the
mains to avoid damaging the projector caused by
lightning or temporary overcurrents.
- Do not stand the projector on unstable surfaces as it
could drop causing serious damage.
- The projector has slots for ventilating the internal
components - do not cover or block them.
- Non posizionare il projector su superfici morbide. Do
not postion the projector on a soft surface.
- The projector should not be made part of a fitted
installation or closed unless there is sufficient ventilation.
- After technical assistance or repairs on the projector
have been completed, ask the technician to carry out a
safety check (all cables and components in the right
position) and to make sure the projector is in proper
operating conditions.
2.2 Power cabling
The projector’s mains power device is shown in the picture
Fig. 2 .
The projector operates at the following mains values:
120-240Vac 50/60Hz 270W 2,5A RMS-MAX, as
specified on the rear label.
The type of fuse used is a 5A, type T (delay).
Warning:
The mains plug is the disconnect device.
Take care when installing that the mains plug and
socket outlet are easily accessible.
Warning:
The projector must be earthed.
Fig. 2
LINE INPUT
• Ve
If the power socket is not equipped with an earth pin, call
your electrician who will install it and ensure its efficiency.
To disconnect the cable pull it out with the plug.
Do not pull the cable itself.
If you use an extension lead, make sure its rating is over
3A and is equipped with an earth wire.
2.3 Servicing
Servicing must be carried out by qualified technicians.
Do not attempt to service the projector without the proper
technical knowledge. Opening the projector can expose
personnel to potential hazards: high voltage and electric
shock.
Unplug the mains cable and call for qualified service
technicians in the following cases:
- when the power cable or plug is damaged
- when liquids are spilled on the projector.
- when rain or water has got inside the projector.
- when the projector is not working properly regardless
of the fact the instructions for use have been followed
correctly
- when the projector has fallen and/or its casing is
damaged (broken).
- when there are noticeable variations in performance that
cannot be corrected with the normal user controls.
Note: Modify only those parameters shown in the user’s
section of the instruction manual. If parameters or controls
are modified that are not shown in the manual a
realignment of the projector might become necessary and
qualified service personnel might have to be called in.
2.4 Spare parts
Use only original Multimedia spare parts.
Using components different from the original spare parts
could lead to:
- A deterioration in performance.
- Fire.
- Electric shock.
- Electrical damage.
- Other.
Failure to observe the above-mentioned warning will
automatically render null void the manufacturer’s
guarantee.