Sim2 Multimedia SVP 420 HB - Manual (Page 37)

SVP 450 PLUS - SVD 500 PLUS
36
5.13.6 Horizontal keystone adjustment
This function allows to overlap the red and blue
horizontal lines on the green ones.
CONV KEY
CRT : RGB
ADJ : R . .
V. = 50
Use the arrow or to set in line the horizontal lines of
the image with the screen borders.
Use the R,G,B, buttons to switch on or off the tubes.
The CRT message: RGB indicates which tubes are
switched on. Use the Rsel, Gsel, Bsel, buttons to select
tube you wish to act. The ADJ message: R. indicates on
which tube you are acting. Press ENTER or EXIT to
change adjustment.
Press ESC to exit.
5.13.7 Convergence pincushion
This function allows to setup the horizontal and
vertical convergence pincushion.
CONV PIN
CRT : RGB
ADJ : R . .
H. = 52 V. = 50
Use the R,G,B, buttons to switch on or off the tubes.
The CRT message: RGB indicates which tubes are
switched on. Use the Rsel, Gsel, Bsel, buttons to select
tube you wish to act. The ADJ message: R. indicates on
which tube you are acting. Press ENTER or EXIT to
change adjustment.
Press ESC to exit.
5.13.8 Convergence borders
This function allows to adjust the image zones
indicated by the crosses.
H. = 50 V. = 60
BORDER
CRT : RGB ADJ / R . .
+
+
H. = 50 V. = 60
BORDER
CRT : RGB ADJ / R . .
+
+
Use the R,G,B, buttons to switch on or off the tubes.
The CRT message: RGB indicates which tubes are
switched on. Use the Rsel, Gsel, Bsel, buttons to select
tube you wish to act. The ADJ message: R. indicates on
which tube you are acting. Press ENTER or EXIT to
change adjustment.
Press ESC to exit.
5.14 Screen quarters corrections
This function allows to perform a fine adjustment of
the image corners.
H. = 50 V. = 60
ZONE
CRT : RGB ADJ / R . .
First of all, you must enter the installation mode.
Press the ZONE button to select on which zone you wish
to act, which will be indicated by .
Whenever you press the ENTER or EXIT buttons, the zone
will be changed.
Use the R,G,B, buttons to switch on or off the tubes.
The CRT message: RGB indicates which tubes are
switched on. Use the Rsel, Gsel, Bsel, buttons to select
tube you wish to act. The ADJ message: R. indicates on
which tube you are acting. Press ENTER or EXIT to
change adjustment.
Press ESC to exit.