Sim2 Multimedia SVP 420 HB - Manual (Page 14)

SVP 450 PLUS - SVD 500 PLUS
13
ENGLISHENGLISHENGLISHENGLISHENGLISH
VIDEO MENU
NOISE RED.
STD SELEC.
BLANKING
WHITE BALANCE
UPC MENU
TLV SYNC
UPC ON
PROGRESSIVE
LINE INSERT
FIELD INSERT
MAIN SETTINGS
MEMO NOR DATA
INSTALL. MENU
MAIN SETTINGS
STORED
MEMO NOR DATA
INSTALL. MENU
The setting USER ADJUSTMENT regards an optional
colour temperature setting, which must be carried out by
a QUALIFIED TECHNICIAN upon installation, should the
end user wish a different colour temperature than the set
ones. The 3200° K colour temperature is used only when
the projector is placed inside television studios. The 6500°
K colour temperature is mostly used being considered
the most pleasant and the one that reproduces colour most
faithfully.
3.17 UPC converter
A UPC converter is installed inside the projector which
doubles the input signal lines for a better quality
picture and reduces common video defects, such as
space between lines and trembling.
The UPC converter, which enhances the video quality and
reduces some comon problems of television video signals,
uses IQTV technology, offering great video picture
improvements such as stability, noise reduction and
increased contrast.
Note: The UPC converter accepts standard signal (CVBS)
and separate synchros (CVS) from 1 VPP to 4 VPP,
(negative only).
To switch the converter on/off, use the UPC button: when
pressed the first time it turns it on, the second time it
switches the converter off. To change the conversion
mode, follow the procedure: press for at least 2
seconds, the screen displays the first menu:
switched on.
The current conversion mode is shown by an arrow on
the left. Use the arrow or to select a different
conversion mode and press ENTER to confirm the
selection. Press EXIT to return to the previous menu.
Press ESC to exit.
Note: The progressive conversion mode is the best one
for using the videoprojector with TV. The line insertion
and field insertion conversion are best used in special
cases (e.g. in broadcasting studios).
3.18 Storing
To store contrast, brightness, colour peaking and hue
parameters as SET values (standard)
.
To store contrast, brightness, colour peaking and hue
parameters as USER values (personal memo)
.
The projector stores two different picture setting
adjustments. The USER adjustment is loaded each time
the switch is ON and the SETadjustmentwhich is loaded
each time the button on the remote control is pressed.
Both adjustments can be changed.
The SET adjustment is used when the adjustment
parameters are changed and one wishes to return to the
initial values.
To change peaking, colour, contrast, brightness and
hue of the set adjustment.
To change the adjustment, press
• • • • • • • • • • • • • • •
thus gaining access to the MAIN PARAMETERS menu.
The following menu is displayed:
Press the arrow or to select UPC MENU and press
ENTER to confirm, the screen displays the second menu:
Use the arrow or to select the function MEMORIZE
NORMALIZED DATA. Press ENTER to confirm the
stored adjustment parameters, the following message is
displayed:
The menu operates only if the UPC converter is