Applying a template to one modem with acemanager – Sierra Raven EDGE User Manual
Page 41
Configuring your Raven
Rev 3.0B Feb.08
37
2. Applying a Template to one modem
with AceManager
You can use a template you created yourself, using the steps
above, or a template provided by your AirLink representative
or someone in your company who has set up a modem
template. The template you wish to apply must be saved to
your hard drive.
a.
Load the template.
1.
Connect to the modem you want to configure
using AceManager.
2.
Click on the Load button on the toolbar.
Figure 5-8: AceManager : Load
3.
Select the template you have saved (you may need
to change folders if you saved it to a different
location).
b.
Verify the configuration settings.
Tip: After you load the template, it’s best to go back over the
AceManager groups to make sure all the settings are what you
require.
c.
Click the Write button on the toolbar to write the
configuration to the modem. Wait for the “Write
Successful” message.
Figure 5-9: AceManager : Write
d.
Reset the modem.
Caution: Many of the configuration settings will not take effect until
the modem has been reset.