Spectra Logic RXT150 - Manual (Page 27)

Chapter 3. Troubleshooting RXT Media
27
Disconnecting the Disk Drive
1. Use a #2 Phillips screwdriver to remove the two screws closest to the open side
of the pack (Figure 3-6).
On Green RXT media, do this only for the drive—or the drive above the drive—
that you are replacing (see Figure 3-7).
2. Carefully turn the pack over to its other side and repeat Step 1.
Caution: The disk drive comes loose immediately when you loosen the
last two screws; be sure to keep one hand on it so that it does
not fall out of the pack.
3. Gently lay the RXT media pack down, with the open side facing up.
Figure 3-6 The screws on one side of a Silver RXT media pack.
Figure 3-7 The screws on one side of a Green RXT media pack.
If you are removing this drive or the one
beneath it, remove these two screws. If you are removing this drive or the one
beneath it, remove these two screws.