Sony PDW-F70 - Manual (Page 43)

43
Recording
Chapt
er
3
Rec
o
rd
ing and
P
la
y
bac
k
Recording
This section describes video and audio recording on the
unit.
See page 81 “Function Menu” in Chapter 6 for more
information about function menu operations.
See page 96 “Setup Menu Operations” in Chapter 6 for
more information about setup menu operations.
It is not possible to combine material recorded in different
system frequencies and audio recording formats on a
single disc (although different bit rates may be combined).
If you attempt to record material in a system frequency or
audio recording format that differs from that of existing
recorded material on the disc, “REC INH” appears on the
display and recording is inhibited.
Make the following settings and adjustments before
starting to record.
Recording format settings: See the next section “To set
the video and audio recording formats”.
Video input signal selection: Select with V INPUT on the
HOME page of the function menu.
Audio input signal selection: Select with A1 INPUT to
A4 INPUT on the HOME page of the function menu.
Timecode and user bits settings: See “Recording
Timecode and User Bit Values” (page 43).
Selection of time data to display: Select with CNTR SEL
on page P1 of the function menu.
Selection of audio channels to monitor: Select with
MONI CH and MONI SEL on page P1 of the function
menu.
Volume adjustment of the monitor audio: Adjust with
the LEVEL knob.
Remote/local setting: Set the remote control switch. If
you set it to REMOTE, also set the setup menu item
INTERFACE SELECT >REMOTE I/F (“REMOTE”
and the connector used appear on the display).
To set the video and audio recording
formats
To set the video recording format
Set the video bit rate (compression method) by setting
OPERATIONAL FUNCTION >REC FORMAT in the
setup menu to one of the following.
To set the audio recording format
Set AUDIO CONTROL >REC MODE in the setup menu
to one of the following.
Recording Timecode and User Bit
Values
There are the following four ways of recording timecode:
Internal Preset mode: This records the output of the
internal timecode generator, set beforehand to an
initial value. The following run modes can be
selected.
• Free Run: Timecode advances continually.
• Rec Run: Timecode advances only during
recording.
Internal Regen mode: This records the output of the
internal timecode generator, initialized to timecode
following continuously upon the timecode of the last
frame of the last clip on the disc.
External Regen mode: This records the output of the
internal timecode generator, synchronized to an
external timecode generator. As the external input, the
timecode input to any of the TIME CODE IN
connector can be selected.
External Preset mode: This directly records the input of
an external timecode generator. As the external input,
the timecode input to either of the following
connectors can be selected.
• TIME CODE IN connector: TC
• HDSDI INPUT connector: LTC
Note
Menu setting/display Video bit rate
HQ VBR 35 Mbps
SP CBR 25 Mbps
LP VBR 18 Mbps
Menu setting Display Audio recording
format
2ch×16bit 2CH 16BIT 2 channels/16 bits
4ch×16bit 4CH 16BIT 4 channels/16 bits
Menu setting/display Video bit rate