Seiko Instruments DPU-30 - Manual (Page 36)

5-8
SI Double–Width Printing Mode Clear
Code 0F
16
Function Clears the double −width printing.
CAN Cancel
Code 18
16
Function Clears the print buffer.
Details • After executing this command, a head of a line is set as a starting position of
printing.
ESC S n1 n2 n3 n4 Bitimage Graphic
Code 1B
16
+ 53
16
+ n1 + n2 + n3 + n4 + [DATA]
Domain of
function
30
16
≤ n1, n2, n3, n4 ≤ 39
16
“0001” ≤ “n1 n2 n3 n4” ≤ “1023”
0 ≤ d ≤ 255 (graphic data)
Function The number of data specified in ASCII code n1, n2, n3 and n4 are specified as a
Bitimage.
Example: Case that 192 Bitimages are specified
1B
16
+ 53
16
+ “0192” + . . . . . . . . .
[192 DATA]
Details • The code outside the domain of function processes the data as the 1-byte data
thereafter.
• If the dots are specified outside the printing area, the data is ignored.
• The data deployment position is set in accordance with the predefined starting
position of the data deployment.
• This command is affected by the inverse printing.
• If the next Bitimage Specify command is received at the occurrence of the line
overflow, the data of the previous line stored in the print buffer is printed. The line
overflow is determined according to the number of dots described below.
− Mode 1: Determined as the line overflow if the number of dots exceeds 276.
− Mode 2: Determined as the line overflow if the number of dots exceeds 332.
• Refer to the figure shown below for how the data is deployed.