Seiko Instruments DPU-30 - Manual (Page 79)

A-1
APPENDIX A. SPECIFICAIONS
General specifications
□
Printing method Thermal line dot
□
Data input
Parallel type 8-bit parallel (Handshake by STROBE and BUSY)
Serial type RS-232C (2400 to 38400 bps, BUSY control, Xon/Xoff control)
□
Dot density
8 dots/mm
□
Maximum printing speed
20 mm/s max. (Power supply 5 V)
50 mm/s max. (Power supply 8.7 V)
□
Command mode
Mode 1: DPU-20-20CF compatible
Mode 2: DPU-20-24CF compatible
Mode 3: ESC/POS compliant
□
Total number of dots, Print width
Mode 1: 278 dot, 34.75 mm
Mode 2: 334 dot, 41.75 mm
Mode 3: 384 dot, 48.00 mm
∗ The print width is aligned at the center.
□
Character mode
Mode 1
(1) Character type ANK: 250 types
(2) Character configuration Standard size character: 24 × 12 dots (H × W)
(3) Font size
3.0 × 1.5 mm (H × W)
(4) Printable character 20 characters with standard characters
(with character spacing of 2 dots)
Mode 2
(1) Character type ANK: 250 types
(2) Character configuration Standard size character: 24 × 12 dots (H × W)
(3) Font size
3.0 × 1.5mm (H × W)
(4) Printable character 24 characters with standard characters
(with character spacing of 2 dots)
Mode 3
(1) Character type ANK: 379 types, and JIS Kanji level I and II
(2) Character configuration Standard size character: 24 × 12 dots, 16 × 8 dots (H × W)
Kanji size character: 24 × 24 dots, 16 × 16 dots (H × W)
(3) Font size Standard size character: 3.0 × 1.5 mm, 2.0 × 1.0 mm (H × W)
Kanji size character: 3.0 × 3.0 mm, 2.0 × 2.0 mm (H × W)