Smart Technologies 3000i - Manual (Page 21)

3000i Installation Guide
13
Powering up the 3000i
1 Locate the AC power cord in the power kit.
2 Plug the this cord into the Main Power IN, located to the right of the Connection Panel.
Location of Main Power Inlet
3 Plug the other end of the power cord into a wall outlet.
4 Go to the front of the cabinet, open the front door, and turn on the computer's main
power switch.
5 Turn on the projector lamp by pressing the Projector Standby button on the Control
Panel (to the right of the SMART Pen Tray). The LED indicator beside this button should
blink rapidly for thirty seconds, and then remain steadily illuminated when the projector
lamp is powered up.
OR
Use the Lamp On/Off button on the projector remote control or on the Control Panel on
top of the projector to turn on the projector lamp.
After a brief, 30-second lamp pre-heat period, the 3000i screen will display an image.
6 You should now adjust the computer settings and image alignment, install the SMART
Board software CD, configure the COM port, and perform a brief orientation procedure.
These procedures are described in the following pages.
Main Power IN