Smart Technologies 3000i - Manual (Page 48)

3000i Installation Guide
40
Appendix B: Removing the Projector (to
Replace the Lamp and Filter)
Replace the lamp when you see the following message: "The lamp has reached the end of its usable
life. Please replace the lamp." To do this, order a replacement standard lamp (MT60LP) or extended
life lamp (MT60LPS) from your NEC or SMART dealer. Generally, you should plan on replacing your
lamp after 2000 hours of use (normal mode).
The instructions for replacing the projector lamp and filter are on pages E-53 and E-54 of the NEC
1065/1060 User's Manual. However, you must first remove the projector from the cabinet. With the
projector in place, there is insufficient clearance above the projector to perform these tasks.
To remove/replace the projector
1 From the front of the cabinet, open the doors and unfasten the two projector straps.
NOTE: For enhanced clarity, the small mirror is not shown.
2 Loosen (without removing) the three front-to-back adjustment screws.
NOTE: For enhanced clarity, the projector straps are shown fastened.
3 Move to the rear of the cabinet and remove the rear access panel (see page 11 for
detailed instructions).
Front-to-Back Adjustment Screws