Smart Technologies 3000i - Manual (Page 37)

3000i Installation Guide
29
Basic Operations
This section describes the following 3000i operations:
• Starting up and shutting down the 3000i
• Putting the projector into standby mode (and restoring normal operation)
• Adjusting the volume
• Adjusting projector settings
• Changing the projector display source
• Using the interactive whiteboard
Starting Up the 3000i
The projector in an 3000i should always remain on; only the power to the projector lamp is
switched on and off at the Control Panel. For greater ease of operation, you should also
keep the computer on all the time. With the projector and computer power always on,
starting up the 3000i requires only that you restore power to the projector lamp (by pressing
the Projector Standby button on the Control Panel) and then enter your user name and
password at the logon screen.
NOTE: To preserve the computer's hard drive(s) and the projector lamp, you may want to
put the computer hard drive and monitor into standby mode. Refer to page 14 for
instructions.
To start up the 3000i
1 If the screen is black, press the Projector Standby button on the Control Panel to power
up the projector lamp. The LED indicator beside the button should blink briefly for
approximately 30 seconds and then remain steadily illuminated when the lamp is fully
powered up.
2 If you see a logon screen, use the wireless keyboard to enter your logon ID and
password, and then press the OK button.
OR
If the screen turns from black to blue (with a SMART logo) – and no logon screen
appears – you may need to power up the computer or restore it from a standby setting.
Open the front door and turn the computer on, or press the reset button (if required).
3 To connect a laptop, refer to pages 21–22.
The table on the next page summarizes possible startup scenarios and related procedures.
Projector Standby Button
LED Indicator of
Lamp Status