Sony SLV-AV100UX - Manual (Page 37)

37 Basic VCR Operations
Recording TV
programmes using
VIDEO Plus+
1 2 3
4 5 6
7 8 9
0 >10
VIDEO Plus+
ENTER
Number
buttons
TIMER REC
ON/OFF
TAPE SPEED
(SP/LP)
Tip
• To cancel the procedure,
press VIDEO Plus+ before
pressing ENTER.
Note
• If the unit’s VCR beeps
repeatedly, the PlusCode is
incorrect.
VIDEO Plus+
SP
SET :
:
SP / LP
– – – – – – – – –
PLUSCODE
0 – 9
SP / LP TAPE SPEED
Just enter the programme’s “PlusCode” listed in the TV programme
guide. The date, times and programme position of that programme are
set automatically. You can preset up to eight programmes at a time.
Before you start…
• Check that the unit’s clock is set to the correct time.
• Insert a tape with its safety tab in place. Make sure the tape is longer
than the total recording time.
• Press VHS TUNER.
– If the TV doesn’t turn on, turn it on manually.
Press VHS TUNER again if connected with a EURO-AV (Scart)
cable.
– If connected with a EURO-AV (Scart) cable, the TV is automatically
set to VCR reception.
– If connected with only the antenna cable, set the TV to the VCR’s
programme position manually.
1
Press VIDEO Plus+.
2
Press the number buttons to enter
the programme’s PlusCode.
If you make a mistake, press TIMER
CLEAR and enter the correct number.
3
Lift the top cover of the remote
commander, then press TAPE
SPEED to select SP or LP.
SP
CONF I RM
:
SP / LP
6 9 1 4 7 7 8 2 –
ENTER
CANCEL T I MER CLEAR
VIDEO Plus+
PLUSCODE
LP
CONF I RM
:
SP / LP
6 9 1 4 7 7 8 2 –
ENTER
CANCEL T I MER CLEAR
VIDEO Plus+
PLUSCODE
continued