Sony SLV-AV100UX - Manual (Page 82)

Additional Information 82
Symptom Remedy
No TV programme appears on
the TV screen.
TV reception is poor.
The tape starts playing as soon
as it is inserted.
The tape is ejected when you
press
r REC.
Nothing happens when you
press
r REC.
Timer recording The timer does not operate.
A tape cannot be inserted.
The tracking indicator does not
appear on the screen.
The unit needs to be cleaned.
• Make sure the TV is set to the video channel. If you are using a
monitor, set it to video input.
• If the unit is connected to the TV using only the aerial cable,
make sure that the RF MODULATOR switch on the rear panel
is set to ON.
• Adjust the TV aerial.
• Place the TV away from the audio components.
• The safety tab has been removed. To record on this tape, cover
the tab hole.
• Check that the safety tab has not been removed.
• Make sure the tape is not at its end.
• If you want to record from other equipment, select the correct
source with the function buttons on the unit. If you select the
input source with the remote commander function buttons, the
remote commander may be switched to control other
equipment. Make sure the remote commander is set for the
unit’s VCR control if you use
r REC on the remote
commander.
If you want to record TV programmes, press VHS TUNER on
the remote commander, then select a programme position.
• Check that the clock is set.
• Make sure a tape has been inserted.
• Check that the safety tab has not been removed.
• Make sure the tape is not at its end.
• Make sure a programme has been set for timer recording.
• Make sure you press TIMER REC ON/OFF to set the unit to
timer recording standby.
• Make sure the current time has not already passed your timer
settings.
• Check that the decoder is turned on.
• Check that the satellite tuner is turned on.
• The clock stops if the unit is disconnected from the mains for
more than one hour. Reset the clock and timer.
• Check that a tape isn’t already in the tape compartment.
• The recording condition of the tape is very poor and tracking
cannot be adjusted.
• Clean the cabinet, panel and controls with a soft, dry cloth, or a
soft cloth slightly moistened with a mild detergent solution.
Do not use any type of solvent, such as alcohol or benzine.
Troubleshooting (continued)
Other VCR
problems
Recording and TV
reception