Sterling SXS Series User Manual
Page 24
BJ5-620 Installation 24
of
73
WARNING! Use caution when operating specific equipment to prevent electrical
shock. Installation, service, alterations, and/or modifications must only be done by
qualified personnel and with high regard for safety. Not conforming to the requirements
could result in bodily harm, death, or costly damage.
NOTE: Alterations to the wiring diagrams require approval. Failure to do this will
exclude all guarantee claims.
The wiring schematics are located in the control panel.
Connection of Emergency Stop Button
The machine may only be operated with installed Emergency Stop buttons. An
Emergency Stop button must be installed at the control cabinet and at the grinding
material in-feed if no Emergency Stop buttons have been installed at the factory.
The control panel with the switches and Emergency Stop button must be installed
near the machine. The distance should not exceed 5 m.
The distance between the floor and the lower edge of the control panel should be at
least 1 m.
The connecting cables between the control panel and the machine must be protected
against damage (cable tray, protective sleeve).
An additional Emergency Stop button has to be installed on the machine If the control
box cannot be installed according to these rules.