Chapter 4: operation – Sterling SXS Series User Manual
Page 27
BJ5-620 Operation 27
of
73
Chapter 4: Operation
4-1 Start-up
WARNING!
No persons should operate the machine until they have read and understand
all parts of the operation manual.
Machine Check—Before Switching Machine ON
9 Cutters and bed knives are properly set and the screws are tightened with the
specified torque.
9 Screen is inserted into the screen support according to the instructions, and the screen
support is fixed at the end position with tightened mounting screws.
9 The cutting chamber is free of foreign matter.
9 The machine and hopper doors are closed.
9 All safety devices, including those of the installed material in-feed and discharge
devices, are checked and operative.
Switch ON Machine
1. Switch ON the material discharge device.
2. Switch ON the shredder (main switch to 1). Wait until the rotor has reached
its full speed and switched from star to delta.
3. Switch ON the hydraulic system.
4. Switch ON the material in-feed device.
4-2 Operation
Procedures
Manual In-feed of Material
DANGER! Rotating
Knives!
Can cause serious cutting and crushing injuries that could result in death.
Do NOT reach into the in-feed hopper or lean in while the rotor is
running. (Pay attention to the run down time). Only use approved
grinding material.