Sterling SXS Series - Manual (Page 46)

BJ5-620 Maintenance 46 of 73
6. Clean the hexagon head socket of the cutter mounting screw (2).
7. Loosen the bolt using a high quality Allen key (10 mm). If necessary knock the
Allen key lightly with a hammer to loosen it.
8. Take out the cutter mounting screw, the washer and the cutter.
9. Clean the hexagon head socket of the knife holder fixing bolts (4).
10. Loose the bolt using a high quality Allen key (6 mm). Knock the Allen key
lightly with a hammer to loose it if necessary.
11. Take out the cutter holder mounting screws (4).
12. Remove the cutter holder with the delivered Extractor.
NOTE: See drawing in “Dismounting the rotor knives”.
WARNING! Danger of cutting caused by sharp knives at all times—even when rotor is at
standstill. Serious Injury especially to the hands and fingers can occur. Wear protective gloves!
Dismounting the Bed Knives
1. Switch OFF the shredder at the main switch.
2. Safeguard main switch using a padlock.
3. Open the hopper door.
4. Safeguard the hopper door.
NOTE: Although it is possible to reach the knives by climbing into the feeding
chamber, it is recommended to access the knives through the front side door.