Sterling SXS Series - Manual (Page 47)

BJ5-620 Maintenance 47 of 73
5. Clean the hexagon head socket of the knife mounting bolts (2) and the cover
plates mounting bolts.
6. Loosen the cover plate mounting bolts using a high quality Allen key (10 mm).
Knock the Allen key lightly with a hammer to loosen if necessary.
7. Take out the bolts and cover plates.
8. Loosen the knife adjusting screws for pulling and take them out.
9. Loosen the knife mounting bolts with Allen key (10 mm). Use a hammer to
lightly knock key if necessary.
10. Take out the knife mounting bolt and knife.
WARNING! Danger of cutting caused by sharp knives at all times—even when rotor is at
standstill. Serious Injury especially to the hands and fingers can occur. Wear protective
gloves!
Mounting the Cutter Holders
1. Clean the cutter pocket and the cutter holder.
2. Insert cutter holder into the pocket.
NOTE: Cutter holder must slide in easily. Do not damage the cutter holder
surfaces with a hammer.
(1) Bed knife
(2) Knife mounting screws
(3) Knife
holder
(4) Cover plates
(5) Knife adjusting screw
for pushing
(6) Knife adjusting screw
for pulling
(7) Cover plate mounting
screws
1
2
6
5
3
4
7