Sterling SXS Series User Manual
Page 45
BJ5-620 Maintenance 45
of
73
Dismounting the Cutters
1. Switch OFF the shredder at the main switch.
2. Safeguard main switch using a padlock.
3. Open the machine door.
4. Safeguard the machine door.
5. Remove screen.
NOTE: Although it is possible to reach the cutting shaft by climbing into the
feeding chamber, it is recommended to access the cutters through the
machine door located at the front of the machine. The shaft can be
rotated manually by turning the motor v-belt pulley.
6. Clean the hexagon head socket of the cutter mounting screw (2).
7. Loosen the bolt using a high quality Allen key (10 mm). Knock the Allen key
lightly with a hammer to loosen it if necessary.
8. Take out the cutter mounting screw, the washer, and the cutter.
Dismounting the Cutter Holders
1. Switch OFF the shredder at the main switch
2. Safeguard main switch using a padlock.
3. Open the machine door.
4. Safeguard the machine door.
5. Remove screen
NOTE: Although it is possible to reach the cutting shaft by climbing into the
feeding chamber it is recommended to access the cutters through the
machine door located at the front of the machine. The shaft can be rotated
manually by turning the motor v-belt pulley.
4
1
2
3
(1) Cutter
(2) Cutter
mounting
screw
(3) Cutter
holder
(4) Cutter
holder
mounting screws