Star Micronics DOT MATRIX PRINTER SP2000 - Manual (Page 15)

13
OUTLINE Sets the magnification rate in character height
Prints the subsequent data with a character height magnified by a
rate specified by the value of n.
n = 0 and "0"' Reset magnification
n = 1 and "1": Double magnification
Note:
• You can print in quadruple magnification by combining
horizontal and vertical double magnification commands.
• You cannot combine with the inverted printed command.
• Line feeds of lines including vertical expansion characters are
doubled.
• When font configuration is 6 X 12 dots of IBM block graphics
characters, only the line amount is doubled.
• The bottom of the characters are aligned when one line
contains both vertical expanded characters and regular
character sizes.
FUNCTION Selects underlining
CODE <ESC> "-" "1" or <ESC> "-" <1>
(1B)H (2D)H (31)H or (1B)H (2D)H (01)H
OUTLINE Data following this code is printed out underlined. (However, the
spaces generated by horizontal tab are not underlined.)
FUNCTION Cancels underlining (Default)
CODE <ESC> "-" "0" or <ESC> "-" <0>
(1B)H (2D)H (30)H or (1B)H (2D)H (00)H
OUTLINE Cancels underlined mode.
FUNCTION Selects upperlining
CODE <ESC> "_" "1" or <ESC> "_" <1>
(1B)H (5F)H (31)H or (1B)H (5F)H (01)H
OUTLINE Data following this code is printed out with an upperline.
(However the spaces generated by horizontal tab are not
upperlined.)