Star Micronics DOT MATRIX PRINTER SP2000 - Manual (Page 41)

39
*1: Comdex Dual Auto Cut Mechanism (STAR mode only)
This mechanism automatically cuts when there is a consecu-
tive paper feed exceedin 7/6 inch. Hosts that cannot send an
escape sequence such as <ESC> “d” and 0, can cut the
paper if a line feed code <LF> of 1/6 inch is sent 7 times
consecutively.
N = 2 (ESC/POS mode)
n1: Always “0”
n2: Always “0”
n3: Always “0”
Parameter Setting “0” to “F”
n4 Paper near end See below
sensor
4) N = 3 (Star mode)
n3: Always “0”
Parameter Setting “0” to “F”
n1 Character table
n2 Character table See below
n4 CR code
n4 Paper near end sensor
“0” or “4” or “8” or “C” Invalid
“1” or “9” or “D” Invalid
“2” or “A” or “E” Reflects status of sensor to STATUS
and when near end, does not go offline
and does not stop printing.
“3” or “B” or “F” Reflects status of sensor to STATUS
and when near end, goes offline and
stops printing.
n4 Comdex dual auto-cutter
“0” to “7” Invalid
“8” to “F” Valid