Star Micronics DOT MATRIX PRINTER SP2000 - Manual (Page 43)

41
N = 3 (ESC/POS mode)
n1: Always “0”
n2: Always “0”
n3: Always “0”
Parameter Setting “1” to “3”
n4 CR code See below
5) N = 4 (Star mode)
n3: Always “0”
Para. Setting “0” “1” “2” “3”
n1 X on/X off Timing When Every 3 When Every 3
Toggled sec Toggled sec
RTS Signal Condition Save as Save as Always Always
DTR DTR SPACE SPACE
n2 Receive buffer size 4 kbytes 4 kbytes 256 bytes 256 bytes
n4 Data receipt error “?” Ignored “?” Ignored
Printed Printed
n4 CR code
“0” Ignores
“1” Ignores
“2” Feeds line after printing (same as <LF>
“3” Prints (no line feed.)
n4 CR code
“0” Prints (no line feed.)
“1” Feeds line after printing (same as <LF>
“2” (Parallel Interface)
Prints and feeds line when nAutoFd signal is “LOW”.
Does not feed line when “HIGH.”
(Serial Interface)
Ignores
“3” Ignores