37 function, Code, Outline – Star Micronics DOT MATRIX PRINTER SP2000 User Manual
Page 39
37
FUNCTION
Sets the memory switch
CODE
<ESC> “# N,
n1 n2 n3 n4” <LF> <NUL>
HEX
1B 23 N 2C
n1 n2 n3 n4 0A 00
OUTLINE
In order to enable changed memory switch settings, turn the
printer OFF and ON again or send the printer reset command
(<ESC> “?” <LF> <NUL>) to the printer. Changed memory
switch settings are stored in EEPROM and these settings will be
stored until they are changed again.
N:
Memory switch number (“0,” “1,” “2,” “3,” “4,” “5,” “6”)
n1 n2 n3 n4: Mode settings (For details see below.)
1) N = 0 (Star mode)
n1: Always “0”
n2: Always “0”
Parameter
Setting
“0” (Default)
“1”
n3
Destination
Standard
Asia Market
n4
FF command *1
See below
*1: Only on printers that have an auto-cutter (SP2520/2560).
*2: Paper feed to cutting position is executed in 1 inch incre-
ments.
N = 0 (ESC/POS mode)
n1: Always “0”
n2: Always “0”
n4: Always “0”
Parameter
Setting
“0” (Default)
“1”
n3
Destination
Standard
Asia Market
n4
<FF> command *1
“0” to “3”
Feeds page
“4” to “7”
Executes full cut after feeding paper to the cut
position. (*2)
“8” to “B”
Feeds page
“C” to “F” Executes partial cut after feeding paper to the cut
position. (*2)