3 installing the hub, 1 tools you will need, 2 preparing the cabinet – Sun Microsystems STOREDGE FC-100 User Manual
Page 24: 3 installing the mounting tray in the cabinet, Installing the hub, Tools you will need, Preparing the cabinet, Installing the mounting tray in the cabinet
Advertising
2-2
Sun StorEdge FC-100 Hub Installation and Service Manual • September 1998
2.3
Installing the Hub
2.3.1
Tools You Will Need
You will need a #2 Phillips screwdriver.
2.3.2
Preparing the Cabinet
Follow the instruction in your system or expansion cabinet documentation. If
necessary, be sure to:
■
Extend the antitilt bar
■
Remove or open the top front panel
■
Remove or open the rear panel
2.3.3
Installing the Mounting Tray in the Cabinet
1. Select the correct mounting holes in the cabinet to use for the tray.
Refer to the online Rackmount Placement Matrix for mounting hole information.
Advertising