Siemens Plant Central Clock TC100 - Manual (Page 95)

Messages
12-9  © Siemens AG 2010 All Rights Reserved
SICLOCK ® TC100 Operating Instructions
Default processor loaded
Warning The default processor was loaded during the start.
Input 1: DCF77 OK
Information After a disturbance, the correct DCF reception has been detected again.
Input 1: DCF77 signal disturbed
Information During stable reception, a disturbance was detected in the DCF77 signal.
Input 1: GPS OK
Information After a disturbance, the correct GPS reception has been detected again.
Input 1: GPS signal disturbed
Information During stable reception, a disturbance was detected in the GPS signal.
Input 1: Signal timeout
Application
(alarm) With monitoring activated, no signal was received within the parameterized timeout.
Check the status display, see Radio clocks via terminals (Chapter 9.1.1). If "no
signal" is shown in the status, check the wiring.
Input 1: Telegram OK
Information A serial format has been detected (for the first time since failure).
Input 1: Telegram cannot be decoded
Information The serial format cannot be decoded.
Firmware has been updated
System and
Information A firmware update has been performed, and the firmware has been updated.
Firmware has NOT been updated
System and
Information A firmware update has been performed, and the firmware could not be updated.
Flash file system has been formatted
System The file system has been formatted.
Protected synchronization
Application
(alarm) The protected synchronization was activated, a discontinuity was detected during the
external synchronization.
The message indicates an external synchronization error. See also Synchronization
(Chapter 9.3.2).
Internal error, please contact Support.
System The message text specifies the exact error, and this is important, e.g. for Support
(Hotline).
Processor has been updated
System and
Information A processor update has been performed, and the processor has been updated.
Table 12-1 Overview of messages, with event type and brief description