Sony KL-X9200U - Manual (Page 11)

Getting Started
GB
11 -GB
Notes
• You can also use the S VIDEO connector on the VIDEO 2 IN
panel on the front of the monitor.
• When you connect the cable to both the VIDEO jack and the S
VIDEO connector, the picture from the S VIDEO connector is
displayed on the monitor screen.
Connecting two VCRs for editing
The monitor outputs the signal input from the VIDEO 1
IN, VIDEO 2 IN or VIDEO 3 IN jacks through the
VIDEO OUT jacks. With two VCRs connected to the
VIDEO IN and VIDEO OUT jacks, you can edit a tape.
Notes
• Signals input from the RGB 1 IN, RGB 2 IN and COMPONENT
IN connectors are not output through the VIDEO OUT jacks.
• Do not connect both the VIDEO IN and VIDEO OUT jacks on
this monitor simultaneously to the video/audio output and
input jacks on a single VCR.
Connecting to video equipment
To a VCR not equipped with an S video
connector
You can also use the VIDEO 2 IN jacks on the front of
the monitor for the video/audio connections.
To an S video equipped VCR
Rear of the monitor
to VIDEO 1 IN or
VIDEO 3 IN
VMC-810S/820S
(not supplied)
VCR
to video/audio outputs
Rear of the monitor
VMC-810S/820S
(not supplied)
VCR for playback
VMC-810S/820S
(not supplied)
VCR for recording
Rear of the monitor
to video/audio
outputs
to video/
audio
inputs
to VIDEO OUT to VIDEO 1 IN
or VIDEO 3 IN
to VIDEO 1 IN or
VIDEO 3 IN
YC-810S
(not supplied)
to S video/audio outputs
VCR
VIDEO IN VIDEO
OUT
COMPONENT IN
Y
P B /C B /B-Y
P R /C R /R-Y
L
AUDIO
R
1 3
S VIDEO
VIDEO
AUDIO
L
R
VIDEO IN VIDEO
OUT
COMPONENT IN
Y
P B /C B /B-Y
P R /C R /R-Y
L
AUDIO
R
1 3
S VIDEO
VIDEO
AUDIO
L
R
VIDEO IN VIDEO
OUT
S VIDEO
VIDEO
AUDIO
L
R
1 3
• If no signal is input to the S VIDEO connector on any of the
VIDEO 1, 2 and 3 IN panels, the S VIDEO connector on the
VIDEO OUT panel does not output a signal.