Siemens SPARC ENTERPRISE M8000 - Manual (Page 21)

Information about Software 13
6449315 The Solaris OS cfgadm(1M) command does
not unconfigure a DVD drive from a domain
on a SPARC Enterprise M8000/M9000 server. Disable the Volume Management Daemon
(vold) before unconfiguring a DVD drive with
the cfgadm(1M) command.
To disable vold, stop the daemon by issuing
the command /etc/init.d/volmgt stop.
After the device has been removed or inserted,
restart the daemon by issuing the command
/etc/init.d/volmgt start
.
6459540 The DAT72 internal tape drive on SPARC
Enterprise M8000/M9000 may time out during
tape operations. Add the following definition to
/kernel/drv/st.conf
:
tape-config-list=
"SEAGATE DAT DAT72-000",
"SEAGATE_DAT____DAT72-000",
"SEAGATE_DAT____DAT72-000";
SEAGATE_DAT____DAT72-000=
1,0x34,0,0x9639,4,0x00,0x8c,0x8c,
0x8c,3;
There are four spaces between SEAGATE DAT
and DAT72-000.
6466617 Performing a hot plug operation with the PCI-
Express slot too quickly interrupts a PCI leaf
reset and occurs the following error:
cfgadm: Component system is busy
error
Pause a few seconds between the issue of each
cfgadm -c
command.
6472153 If you create a Solaris OS Flash archive on a
non-SPARC Enterprise M4000/M5000 sun4u
server and install it on a SPARC Enterprise
M4000/M5000 sun4u server, the console's TTY
flags will not be set correctly. This can cause
the console to lose characters during stress. This bug has been fixed in Solaris 10 5/08.
For Solaris 10 8/07 or earlier, this has been
fixed in patch 137046-01.
[Workaround]
Just after installing Solaris OS from a Solaris
Flash archive, telnet into the SPARC Enterprise
M4000/M5000 server to reset the console's
TTY flags a follows:
# sttydefs -r console
# sttydefs -a console -i "9600 hupcl
opost onlcr crtscts" -f "9600"
This procedure is required only once.
TABLE 4 Solaris OS Issues and Workarounds (Continued)
CR ID Description Workaround