Siemens SPARC ENTERPRISE M8000 - Manual (Page 26)

18 SPARC Enterprise M8000/M9000 Servers Product Notes for XCP Version 1072 • September 2008
6522433 After the CPU hardware error occurred, the
fmdump
(1M) command on the domain may
display an incorrect faulty component.
This bug has been fixed in Solaris 10 5/08. For
Solaris 10 8/07 or earlier, this has been fixed in
patch 127127-11.
[Workaround]
Check system status on XSCF.
6527781 The cfgadm command fails while moving the
DVD/DAT drive between two domains. This bug has been fixed in Solaris 10 8/07.
For Solaris 10 11/06, this has been fixed in
patch 125081-06.
There is no workaround. To reconfigure
DVD/Tape drive, execute reboot -r from
the domain exhibiting the problem.
6527811 The showhardconf(8) command on the XSCF
cannot display PCI card information that is
installed in External I/O Expansion Unit, if the
External I/O Expansion Unit is configured
using PCI hotplug. This bug has been fixed in Solaris 10 5/08.
For Solaris 10 8/07 or earlier, this has been
fixed in patch 128346-01.
There is no workaround.
6529714 Warning messages occur while trying to
configure more than four X4447A-Z or
X1027A-Z1 cards into one I/O Boat. There is no workaround.
6530178 DR addboard(8) command can hang. Once
problem is observed, further DR operations are
blocked. Recovery requires reboot of the
domain. This bug has been fixed in Solaris 10 8/07.
For Solaris 10 11/06, this has been fixed in
patch 120011-07.
There is no workaround.
6530288 Ap_Id format may not be shown correctly by
cfgadm
(1M) command.
This bug has been fixed in Solaris 10 8/07.
For Solaris 10 11/06, this has been fixed in
patch 120011-07.
There is no workaround.
6530753 Some of the PCI slots in the External I/O
Expansion Unit PCI slots are not displayed
during a normal boot operation. Use one of the following operations to display
all of the PCI slots.
• boot -r (at open boot prompt)
• devfsadm -C (at Solaris prompt)
• cfgadm (twice at Solaris prompt)
6531036 The error message network
initialization failed
appears
repeatedly after a boot net installation.
There is no workaround. This message can be
safely ignored.
TABLE 4 Solaris OS Issues and Workarounds (Continued)
CR ID Description Workaround