Siemens SPARC ENTERPRISE M8000 - Manual (Page 30)

22 SPARC Enterprise M8000/M9000 Servers Product Notes for XCP Version 1072 • September 2008
6559504 Messages of the form nxge: NOTICE:
nxge_ipp_eccue_valid_check: rd_ptr = nnn
wr_ptr = nnn will be observed on the console
with the following cards:
• X4447A-Z, PCI-e Quad-port Gigabit
Ethernet Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
This bug has been fixed in Solaris 10 5/08.
For Solaris 10 8/07, this has been fixed in
patch 127741-01.
[Workaround]
These messages can be safely ignored.
6564934 Performing a DR deleteboard(8) operation
on a board which includes Permanent Memory
when using the following network cards
results in broken connections:
• X4447A-Z, PCI-e Quad-port Gigabit
Ethernet Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
This bug has been fixed in Solaris 10 5/08.
For Solaris 10 8/07, this has been fixed in
patch 127741-01.
[Workaround]
Re-configure the affected network interfaces
after the completion of the DR operation. For
basic network configuration procedures, refer
to the ifconfig man page for more
information.
6568417 After a successful CPU DR deleteboard(8)
operation, the system panics when the
following network interfaces are in use:
• X4447A-Z, PCI-e Quad-port Gigabit
Ethernet Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
This bug has been fixed in Solaris 10 5/08. For
Solaris 10 8/07 or earlier, this has been fixed in
patch 127111-02.
[Workaround]
Add the following line to /etc/system and
reboot the system:
set ip:ip_soft_rings_cnt=0
6571370 Use of the following cards have been observed
to cause data corruption in stress test under
laboratory conditions:
• X4447A-Z, PCI-e Quad-port Gigabit
Ethernet Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
This bug has been fixed in Solaris 10 5/08. For
Solaris 10 8/07, this has been fixed in patch
127741-01.
[Workaround]
Add the following line in /etc/system and
reboot the system: set
nxge:nxge_rx_threshold_hi=0
6572827 On SPARC Enterprise M8000/M9000 servers,
one of the columns in the IO Devices section of
the output from prtdiag -v is "Type". This
reports "PCIe", "PCIx", "PCI" or "UNKN" for
each device.
The algorithm used to compute this value is
incorrect. It reports "PCI" for PCI-X leaf
devices and "UNKN" for legacy PCI devices. There is no workaround.
TABLE 4 Solaris OS Issues and Workarounds (Continued)
CR ID Description Workaround