Siemens SPARC ENTERPRISE M8000 - Manual (Page 43)

Information about Software 35
18. Install Solaris 10 5/08.
19. Use the setdomainmode(8) command, enable the autoboot function of the
domain.
For detail, see the SPARC Enterprise M4000/M5000/M8000/M9000 Servers XSCF User’s
Guide. The autoboot function is applied by a domain reboot.
Upgrading an On-CMU SPARC64 VI to SPARC64
VII, or Adding SPARC64 VII to an Existing CMU,
to an Existing Domain Configured with SPARC64
VI
1. When the Solaris OS version is Solaris 10 8/07, upgrade it to Solaris 10 5/08 or
apply the mandatory patches described in “Solaris OS Patch Information” on
page 2 .
2. To use SPARC64 VII processors, apply the relevant patches to the software in use,
if necessary.
3. Log in to the XSCF on an account with platform administrative privileges.
4. Use the showstatus(8) command to confirm that a component in Faulted or
Deconfigured status doesn't exist.
If no failures found, the following message appears: "No failures found in
System Initialization.
" In case of other messages, contact a service engineer
before proceeding to the next step.
5. Turn off the power to a domain assigned the CMU of which you upgrade or add
the CPU.
6. Confirm that the target domain stopped.
7. Change the key position on the operator panel from Locked to Service.
XSCF> showstatus
XSCF> poweroff -d domain_id
XSCF> showlogs power