Siemens SPARC ENTERPRISE M8000 - Manual (Page 29)

Information about Software 21
6542632 Memory leak in PCIe module if driver attach
fails. This bug has been fixed in Solaris 10 8/07.
For Solaris 10 11/06, this has been fixed in
patch 120011-09.
There is no workaround.
6545143 When kcage thread is expanding the kcage
area, if the user stack exists in the expanded
area, its area is demapped and might cause a
ptl_1 panic during the flushw handler
execution. This bug has been fixed in Solaris 10 5/08. For
Solaris 10 8/07 or earlier, this has been fixed in
patch 127111-08.
There is no workaround.
6545685 If the following message displayed on the OS
console, memory degradation or XSB
deconfiguration may occur in the subsequent
reboot.
Example:
mc-opl: WARNING: mc-opl rewrite
timeout on /LSB0/B0
This bug has been fixed in Solaris 10 5/08.
For Solaris 10 8/07 or earlier, this has been
fixed in patch 127111-08.
[Workaround]
Add the following to /etc/system and then
reboot the domain:
set mc-opl: mc_max_rewrite_loop =
20000
6546188 The system panics when running hotplug
(cfgadm(1M)) and DR operations
(addboard(8) and deleteboard(8)) on the
following cards:
• X4447A-Z, PCI-e Quad-port Gigabit
Ethernet Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
This bug has been fixed in Solaris 10 5/08.
For Solaris 10 8/07, this has been fixed in
patch 127741-01.
There is no workaround.
6551356 The system panics when running hotplug
(cfgadm(1M)) to configure a previously
unconfigured card. The message "WARNING:
PCI Expansion ROM is not accessible" will be
seen on the console shortly before the system
panic. The following cards are affected by this
defect:
• X4447A-Z, PCI-e Quad-port Gigabit
Ethernet Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
This bug has been fixed in Solaris 10 5/08.
For Solaris 10 8/07, this has been fixed in
patch 127741-01.
[Workaround]
Perform cfgadm -c disconnect to
completely remove the card. After waiting at
least 10 seconds, the card may be configured
back into the domain using the cfgadm -c
configure
command.
TABLE 4 Solaris OS Issues and Workarounds (Continued)
CR ID Description Workaround