SMC Networks Air Weigh AW5800 - Manual (Page 20)

20
Install comlink and display gauge in cab at this time. Return
to sensor installation after glue has cured. Do not move the
vehicle with the alignment tool installed.
19. Remove the alignment tool from the brackets. It should
fit loosely. Save the two 3/8 bolts (131-0037-001) and 3/8
nuts (132-0014-000) for re-use during installation of the
Deflection Sensor. Apply epoxy paint on glue area and axle
to cover surface where glue bonds to axle and let dry.
20. Clean the bracket channels with (1) of the alcohol pads.
21. Sensor insertion. Clean the sensor ends (010-9089-
000) with the (1) remaining alcohol pad.
22. Insert the sensor with its cable extending away from the
side of the vehicle where you
’ll route the sensor extension
cable to
the firewall. The “TOP” lettering at the opposite end
should face up. (See Step 2 on page 8 in the Installation
Overview Drawings, showing an installation with routing
planned on the driver side; or Alternate Step 2 on page 9 in
the Installation Overview Drawings showing an installation
with routing planned on the passenger side.)
Figure 10