SMC Networks Air Weigh AW5800 - Manual (Page 21)

21
23. Mount the sensor in the channels. Align the sensor with
the bracket holes (Figure 10, previous page).
24. Place a 3/8" ID flat washer (133-0009-000) on one of
the 3/8" x 2 1/4" bolts (131-0037-001) saved in Step 16.
Figure 11-A
Driver Side Cable Run
Note:
See 26-P, page 23, for passenger side cable run.
25-D. Driver side cable run. Insert one of the bolts with
washer through the bracket hole on the sensor end without
the TOP label on it, from the front of the vehicle to the rear.
(Figure 11-A)